Heavy Duty B260 Raised Edge Trim (3m)

The B260 is the standard raised edge trim and one of the four trims used on most domestic Cure It roofs. It creates an upstand along the roof edges that should not drain, holding water on the roof and guiding it to the drip edge.

Key features

• Standard-size raised edge (upstand) trim
• Prevents water running off non-draining edges
• Heavy duty version available
• Works with C1, C2, C4 corners and the C8B expansion closure
• Made from GRP, with a matt high-adhesion side for bonding and a glossy side; always bond to the matt side.

Where it is used

Flat roof edges that must not drain, such as verges and side edges.

Specification

Product code TRB260. GRP. 3m lengths as standard.

Installation note

Fix a single batten level with the top edge of the deck, run a continuous bead of Cure It Trim Adhesive along it, rub the trim into place and nail through the top of the trim into the decking, never through the front face. Where a ladder will regularly rest against the trim, reinforce it (double up the trim, add an extra layer of laminate and tissue, or fit a shaped timber batten into the ridge). Fix with 13mm galvanised clout nails or a stapler into the decking: at each end, the middle, then 100mm centres. Use Cure It Trim Adhesive (silicone or general-purpose mastic is not suitable). Bandage every joint between trim sections and between trim and decking. Always follow the current Cure It installation guide.

Compatibility

Corners: C1, C2, C4. C8B expansion closure (with E280).